{{:WincorNixdorf.jpg}}
LCD4Linux supports the serial cashier displays BA63 and BA66 made by [[http://www.wincornixdorf.com|WincorNixdorf]].
{{:BA63.jpg}}
{{:BA66.jpg}}
There are two drivers for these displays: The //WincorNixdorf// (recommended) and the [[:SimpleLCD|SimpleLCD]] driver.
----
===== Display Section =====
Display {
Driver 'WincorNixdorf'
Model
Port
Speed 9600
SelfTest <0|1>
BarChar
}
----
===== Parameters =====
|**Driver**|'WincorNixdorf'|
|**Model**|'BA63' or 'BA66'|
|**Port**|serial device the display is attached to (e.g.'/dev/ttyS2')|
|**Speed**|the baud rate from the display must match this value. WincorNixdorf displays usually run at 9600 baud.|
|**SelfTest**|set to 1 to trigger the display selftest on startup (will take about 15 seconds)|
|**BarChar**|ASCII value for the char used to draw bars. 219 looks like a big full block.|
----
===== Example =====
The following configuration works for a BA63 display.
Display BA63 {
Driver 'WincorNixdorf'
Model 'BA63'
Port '/dev/tts/0'
Speed 9600
SelfTest 1
BarChar 219
}
----